Effect of oxygen on regulation of properties of moderately boron-doped diamond films

Regulation of oxygen on properties of moderately boron-doped diamond films is fully investigated. Results show that, with adding a small amount of oxygen (oxygen-to-carbon ratio < 5.0%), the crystal quality of diamond is improved, and a suppression effect of residual nitrogen is observed. With increasing ratio of O/C from 2.5% to 20.0%, the hole concentration is firstly increased then reduced. This change of hole concentration is also explained. Moreover, the results of Hall effect measurement with temperatures from 300 K to 825 K show that, with adding a small amount of oxygen, boron and oxygen complex structures (especially B₃O and B₄O) are formed and exhibit as shallow donor in diamond, which results in increase of donor concentration. With further increase of ratio of O/C, the inhibitory behaviors of oxygen on boron leads to decrease of acceptor concentration (the optical emission spectroscopy has shown that it is decreased with ratio of O/C more than 10.0%). This work demonstrates that oxygen-doping induced increasement of the crystalline and surface quality could be restored by the co-doping with oxygen. The technique could achieve boron-doped diamond films with both high quality and acceptable hole concentration, which is applicable to electronic level of usage.     

Melting thermodynamics of oligonucleic acids conjugated with relatively solvophobic linear polymers: A coarse‐grained molecular simulation study

Oligonucleic acids (ONAs), such as DNA and RNA, are used in various biotechnology and nanotechnology applications due to their ability to form a double helix that is stable at low temperature and melts at high temperatures. The melting temperature (T_m) of ONA duplexes can be tuned by the ONA composition, sequence, length and concentration, solvent quality, and salt concentration and by conjugation to other macromolecules. In this article, we use coarse‐grained (CG) molecular simulations to study ONAs conjugated with linear homopolymers that are relatively more solvophobic than the ONA. We study charged and stiff 8‐mer ONAs (e.g., DNA) and neutral and flexible 8‐mer ONAs (e.g., peptide nucleic acids or PNA), and vary the composition (or G‐C content) and sequence of ONA, conjugated homopolymer lengths and solvent quality for the polymer. For neutral and flexible ONAs, as the solvent quality worsens for the polymer, the ONA melting temperature increases from that of unconjugated ONA. The melting curves broaden with polymer length and worsening solvent quality, especially for ONAs with higher G‐C content. For charged and stiff ONAs, as the solvent quality worsens, the ONA melting temperature decreases compared to unconjugated ONA while the width of the melting curve remains the same. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2019 , 57, 1196–1208     

In vitro anticomplementary activity and quality evaluation of dried blossoms of Inula nervosa Wall. from different geographical origins

Blossoms of Inula nervosa Wall. (BINW) are traditionally used as an analgesic and antitussive in China. In this study, in vitro anticomplementary activities of crude extract from BINW in 21 batches and of extracts of four monomeric compounds were evaluated by the classical pathway. The effect of the region of origin on the quality of BINW was evaluated by fingerprint analysis for the first time. Furthermore, chemometric methods including similarity analysis and principal component analysis were employed to evaluate the quality of BINW. The nine major monomeric compounds were quantitated by ultra‐high‐performance liquid chromatography. All nine analytes demonstrated excellent linearity with recoveries ranging from 97.25% to 102.76%. The limits of detection and quantification were 0.07–12.20 μg/mL and 0.22–40.27 μg/mL, respectively. Results indicate that different regions of origin have a significant effect on the quality of BINW. Fingerprint analysis in combination with chemometrics and multi‐ingredient determination is an efficient and reliable approach for quality evaluation. The BINW samples from Yunnan had the highest ratio of 1,5‐dicaffeoylquinic acid and thymol; they also exhibited significantly higher anticomplementary activity than those from three other areas. This study successfully established a rapid and efficient method to evaluate the quality and biological activity of BINW.     

基于计算机视觉技术的茶叶品质随机森林感官评价方法研究

为弥补茶叶品质感官审评存在的缺陷，利用计算机视觉技术对茶叶品质进行快速无损评价研究。以碧螺春绿茶为对象，依据专家感官审评结果，将茶样分成4个等级；采用中值滤波及拉普拉斯算子对茶样图像进行预处理，并提取预处理后的茶样图像的颜色特征和纹理特征以表征茶叶图像的外形特征，利用随机森林算法对茶叶外形特征属性进行重要性排序；筛选出重要性较大的特征及随机森林算法中最优的决策树棵数建立感官评价模型，并与建立的支持向量机(SVM)模型性能相比较。结果表明：色调均值、色调标准差、绿体均值、平均灰度级、饱和度均值、红体均值、饱和度标准差、亮度均值、一致性等9个特征属性的重要性较大，且与感官审评特征描述结果相一致；当采用优选出的9个重要性较大的特征及决策数棵数为500时，建立的模型性能最优，模型总体判别率为95.75%，Kappa系数为0.933，OOB误差为5%，较SVM模型分别提高了3.5%，0.066，优选的9个重要性较大的图像特征与感官审评特征描述相一致。研究表明：利用随机森林方法筛选出对茶叶外形特征属性贡献最大的少数几个特征建立模型，模型性能就能达到很好的识别效果，模型得到简化，同时模型精度和稳定性都高于其他方法。     

科研成果向教学实验的转化设计与实践成效*

围绕学校高水平应用型人才培养目标,依托省级重点实验室与省级化学化工大学生创新训练中心等科研教学平台,将“零排放型化学镀镍及其废液资源化为掺杂型LiFePO₄/C复合材料”的科研成果进行拆解和提炼,设计为分阶段、多层次的10个教学实验项目,并予以实践。结果表明,该科教融合模式营造出良好的科研氛围,有利于学生科研素养与创新意识的培养、实践能力与创新能力的提升。     

A 3D mesh deformation technique for irregular in‐flight ice accretion

Aircraft holding around busy airports may be requested to sustain as much as 45 min of icing before landing or being diverted to another airport. In this paper, a three‐dimensional mesh deformation scheme, based on a structural frame analogy, is proposed for the numerical simulation of ice accretion during extended exposure to adverse weather conditions. The goal is to provide an approach that is robust and efficient enough to delay or altogether avoid re‐meshing while preserving (enforcing) nearly orthogonal elements at the highly distorted ice surface. Robustness is achieved by suitably modifying the axial and torsional stiffness components of the frame elements in order to handle large and irregular grid displacements typical of in‐flight icing. Computational efficiency is obtained by applying the mesh displacement to an automatically selected small subset of the entire computational domain. The methodology is validated first in the case of deformations typical of fluid‐structure interaction problems, including wing bending, a helicopter rotor in forward flight, and the twisting of a high‐lift wing configuration. The approach is then assessed for aero‐icing on two swept wings and compared against experimental measurements where available. Copyright © 2015 John Wiley & Sons, Ltd.     

Electrochemical sensors for environmental gas analysis

The application of electrochemical sensors for measurement of concentration of pollutant gases in air in the part-per-billion (10⁹) range is reviewed. Performance-limiting factors, particularly the effects of extremes and of relatively rapid changes in ambient temperature and humidity, are noted. Variations in composition of the electrolyte in the meniscus at the electrode–gas interface and instability of the solid–liquid–gas contact line, causing important variations in current due to background electrode reactions, are deduced and suggested as the reason for the performance limitations. Suggestions are made for mitigation through instrument design.     

燃气透平叶片表面颗粒沉积特性数值研究进展

污染物颗粒在燃气透平叶片表面及冷却通道内的沉积将影响透平叶片的冷却特性和安全服役寿命。国外许多研究机构对燃气透平叶片表面污染物颗粒沉积特性及其与叶片气膜冷却的相互作用机制进行了持续研究。本文首次系统总结了近年来燃气透平叶片表面污染物颗粒沉积特性数值研究进展,重点介绍了燃气透平叶栅流道内污染物颗粒的沉积机制、颗粒沉积和脱离物理模型以及颗粒沉积与透平叶片冷却特性相互作用的数值模拟方法和研究成果。基于当前研究热点和发展趋势,结合作者的研究经历,指出了国内在研发先进燃气轮机透平冷却结构时应注意的问题和方向,为高效、燃料适应性更广的燃气轮机技术自主开发奠定基础。     

基于多通道盲识别的自适应光学图像事后处理

为实时恢复天文或空间目标的湍流退化成像,提出一种适应大气湍流动态变化的多通道自适应光学图像恢复方法.以自适应光学校正后不同时刻的目标成像作为多个通道,建立求解系统点扩散函数的线性方程,根据解出的点扩散函数利用超拉普拉斯算法,求解待观测目标的估计值.结果表明:不同时刻的点扩散函数之间存在互质关系,满足多通道盲识别的理论要求.利用建立的线性方程求解出的点扩散函数与原点扩散函数的均方误差在10^-30~10^-27量级,采用超拉普拉斯算法恢复出的目标成像与原始目标之间的均方误差在10^-5~10^-4量级.本文研究为湍流退化图像的实时恢复提供了理论基础.     

Quantitative characterization of holographic displays based on liquid-crystal-on-silicon spatial light modulator

This report discusses the effect of speckle size on the quality of holographic images based on a liquid-crystal-on-silicon (LCoS) spatial light modulator (SLM). Further, it proposes methods of quantifying the average speckle size and holographic image resolution. These methods enable both characteristics to be compared using the same unit (the number of pixels in the holographic image), providing an intuitive and effective comparative analysis method. In particular, by varying the LCoS resolution ratio, the change in the resolvable minimum pixels of the holographic image is interpreted in conjunction with the average speckle size; moreover, an analysis of the correlation between the latter two is presented. This approach, based on LCoS resolution division, could provide useful insights into single-SLM-based, full-color holographic displays using space division. Furthermore, it could be extended to other components, including more advanced LCoS SLMs, and used to identify the relative effects on image quality with speckles.